Design for Manufacturability

April 26, 2019

dchiu

NX CAD, Rewind

0

In this 38-minute webinar, Application Engineer David Chiu covers Design for Manufacturability software in NX which automatically checks for design flaws that are expensive, difficult, or impossible to manufacture so you can avoid expensive and time-consuming rework.

Design for Manufacturability software also suggests how to correct the problem once it is identified. Use it to validate molds and dies, assemblies, sheet metal, and milled parts.

Complete this form to watch the rewind on-demand.

Topics covered:

  1. Design Validation with Check-Mate
  2. Check-Mate Demo
  3. DFM Pro Design Check Examples
  4. DFM Pro Mold Demo
  5. DFM Pro Milled Part Demo
  6. DFM Pro Cost Savings
  7. Q&A

Complete the form below to watch the rewind on-demand.

Post by David Chiu

Leave a Reply

Your email address will not be published. Required fields are marked *